Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 86

Setting Up IOS Access Points
Note
You can use either Telnet or SSH (secure shell protocol) to push configuration
Step 3
templates to IOS access points. To use templates to configure IOS access points,
you must configure either Telnet or SSH or both.
•
•
To enable SNMP:
Step 4
a.
b.
c.
d.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-8
If you do not wish to use CDP, you can add all access points as seeds or
import devices. For more information, see
To enable and configure SSH (secure shell protocol), enter the following:
Select SERVICES > Telnet/SSH.
1.
Enable Secure Shell.
2.
Enter a System Name.
3.
4. Enter a Domain Name (for example, cisco.com).
(Optional) Enter the RSA key size.
5.
(Optional) Enter the Authentication Timeout.
6.
(Optional) Enter Authentication Retries.
7.
Click Apply.
8.
To enable and configure Telnet:
Select SERVICES > Telnet/SSH.
1.
Enable Telnet.
2.
3. (Optional) Enable Teletype.
Enter the number of Columns.
4.
Enter the number of Lines.
5.
Click Apply.
6.
Select Services > SNMP.
After Simple Network Management Protocol (SNMP), select Enabled.
Enter the System Name (sysName), System Location (sysLocation), and
System Contact (sysContact).
Click Apply.
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Discovering Devices, page 6-7.
78-16345-01