Table of Contents
Advertisement
Chapter 6
Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Configuring Discovery Options
Step 1
Step 2
Discovering Devices
78-16345-01
Discovery options allow you to enable automatic management of all discovered
devices, specify use of device names in displays, and use MAC address filtering
for management of access points. This step is optional.
To configure discovery options, perform the following steps:
Select Devices > Discover > DISCOVER > Advanced Options.
If you want device names in WLSE displays, instead of their IP addresses,
a.
select Use Reverse DNS lookup.
To enable automatic management for all discovered devices, select
b.
Auto-Manage Devices. Otherwise, you must move devices to the managed
state after they have been discovered.
To arrange temporary management of access points, you can configure MAC
c.
filtering. For information, see the online help or the User Guide for the
CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Click Save.
d.
To set up IP filters for limiting discovery to certain devices, select Devices >
Discover > DISCOVER > IP Filter Rules and follow the instructions in the
online help or the User Guide for the CiscoWorks Wireless LAN Solution Engine,
Release 2.7.
Use the procedures in this section to discover devices by using CDP or device
import:
Use the discovery wizard to run a CDP discovery—See
•
page
6-8.
If you prefer not to use CDP, use the wizard and enter all of your
Note
devices as seeds, as indicated in the following procedure, or import
devices.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Configuring Discovery Options
Run CDP Discovery,
6-7
Advertisement
Table of Contents
