General Precautions - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Safety
Warning
Warning
Warning
Warning
Warning

General Precautions

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
2-4
Ultimate disposal of this product should be handled according to all national
laws and regulations. Statement 1040
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord. Statement 1
Read the installation instructions before connecting the system to the power
source. Statement 1004
The ports labeled "Ethernet," "10BaseT," "Token Ring," "Console," and "AUX"
are safety extra-low voltage (SELV) circuits. SELV circuits should only be
connected to other SELV circuits. Because the BRI circuits are treated like
telephone-network voltage, avoid connecting the SELV circuit to the telephone
network voltage (TNV) circuits. Statement 22
There is the danger of explosion if the battery is replaced incorrectly. Replace
the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions. Statement 1015
Observe the following general precautions when using and working with your
system:
• Keep your system components away from radiators and heat sources, and do
not block cooling vents.
• Do not spill food or liquids on your system components, and never operate
the product in a wet environment. If the computer gets wet, see the
appropriate chapter in your troubleshooting guide or contact the Cisco
Chapter 2 Preparing to Install WLSE 1130-19 Hardware
78-16345-01