Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 39

Chapter 2 Preparing to Install WLSE 1130-19 Hardware
This unit might have more than one power cord. To reduce the risk of electrical
Warning
shock, disconnect all power supply cords before servicing the unit. Statement
106
This product relies on the building's installation for short-circuit (overcurrent)
Warning
protection. Ensure that a fuse or circuit breaker no larger than 120VAC, 20A U.S.
(240VAC, 16 to 20A international) is used on the phase conductors (all
current-carrying conductors). The fuse or circuit breaker must have adequate
safety approvals recognized by the country of usage. Statement 119
This equipment is intended to be grounded to comply with emission and
Warning
immunity requirements. Ensure that the switch functional ground lug is
connected to earth ground during normal use. Statement 1064
Blank faceplates and cover panels serve three important functions: they
Warning
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity. Statement 1001.
The power supply circuitry for the equipment can constitute an energy hazard.
Warning
Before you install or replace the equipment, remove all jewelry (including
rings, necklaces, and watches). Metal objects can come into contact with
exposed power supply wiring or circuitry inside the DSLAM equipment. This
could cause the metal objects to heat up and cause serious burns or weld the
metal object to the equipment. Statement 207
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Safety
2-3