Configuring The Web Browser; Supported Browsers - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Configuring the Web Browser

Step 4
Step 5
Step 6
Configuring the Web Browser

Supported Browsers

Note
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
4-8
Enter the show config command to verify that the configuration is as you
expected. For more information on this command, see the User Guide for the
CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Enter the show clock command to verify that the system time and date are correct
in Coordinated Universal Time (UTC).
If the time or date is incorrect, set the correct time and date using the clock
•
command.
If your network uses NTP, configure the system to use NTP to set the clock.
•
Enter the exit command to log out.
You are now finished using the console. The remaining steps take place at the
client system.
Normally, all WLSE tasks are performed in the Web interface. Before you connect
to the Web interface, make sure you are using a supported browser and that the
browser is properly configured.
Supported Browsers, page 4-8
•
Configuring Internet Explorer, page 4-9
•
Configuring Netscape Navigator, page 4-10
•
Before connecting to the WLSE web interface, make sure you are using a
supported browser and the browser is properly configured. The supported
browsers for WLSE 2.7 are listed in
Configuring Internet Explorer, page 4-9
page 4-10 to configure the browser.
Using earlier, unsupported versions of Internet Explorer compromises the
security of the WLSE.
Chapter 4 Basic Setup—CiscoWorks 1105/1130/1130-19
Table 4-4 on page 4-9. Use the procedures in
or Configuring Netscape Navigator,
78-16345-01