Table of Contents
Advertisement
If the Starter Kill is installed, your vehicle will benefit from a protection against starter motor
damage that could occur after remote-starting the engine should the user, by force of habit,
turn the ignition key to the
Starter Kill / Anti-grind feature
With this added security feature, the system will prevent your vehicle from starting with the
ignition key when the Starter Kill is armed. If your system was installed with the Starter Kill
option, one will not be able to start your vehicle with the Key unless the system has been
unlocked and disarmed first, or put into Valet Mode.
If the Starter Kill is installed, your vehicle will benefit from a protection against starter motor
damage that could occur after remote-starting the engine should the user, by force of habit,
turn the ignition key to the
Active / Passive Arming of the Starter Kill
The Starter Kill can be configured to either Passive mode (so as to arm automatically) or Active
Mode (so as not to arm automatically). In Passive Mode, the system can be configured to arm
automatically either after 1 minute or after 3 minutes. The Starter Kill is configured by default
for a 1-minute Passive Arming Delay: the Starter Kill will automatically arm 1 minute after the
ignition key is turned back to the
configuration.
If the Key Sense option is installed (see p. 8), the system will not arm while the ignition key
remains in the ignition switch. If the Door Trigger option is installed, the system will not arm
while a door remains open.
See p. 6 for more detailed instructions on how to arm and disarm the Starter Kill.
Idle Mode Option
If configured at installation, this feature will allow the user to remove the ignition key from the
ignition switch and leave the vehicle running without the key. (See Idle Mode on p. 3 for
details.)
Ignition-controlled Door Locks Option
This is an added security feature. If your system was installed with the Ignition-controlled Door
Locks option, the doors will automatically be locked as soon as the brake pedal is pressed after
the ignition key has been turned to the
to the
position, the doors will automatically be unlocked.
OFF
Smart Ignition Locks Option
If the Ignition-controlled Door Locks option is configured at installation, the Smart Ignition Locks
option may be configured as well, with the following effect: whenever the brake pedal is
pressed while the ignition key is in the
any door that has been previously unlocked, opened and closed.
LOCK
Secure Lock Option
Before it can remote-start your vehicle, the module must first disarm the factory security
system.
The Secure Lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started.
Once the engine run cycle ends, Secure Lock will rearm your factory security system.
Priority Door Access Option
When programmed, this safety feature lets you selectively unlock either all doors
simultaneously, or the driver's door (leaving all other doors locked). See Priority Door Access
on p. 6 for details.
AS-1525 SH User Guide
position.
CRANK
position.
CRANK
position – or until the last door is closed, depending on the
OFF
IGNITION ON
IGNITION ON
(
) position. When the ignition key is turned
RUN
(
) position, the system will automatically
RUN
P.7
Advertisement
Table of Contents
