During Playback - Sony PDW-F1600 Operation Manual

During recording and editing operations
Alarm message in time
data display area
a)
Input Sig!"
a)
ILL. REC!
a)
ILL. REF!
a)
MEM. Full!
Verify ERR!
Recording
Cache Full!
Clip End!
Disc Full!
a)
REC Format!
a)
Preroll!
a)
Last Clip!
Live Logg!
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on" or "limit".

During playback

Alarm message in time data
display section
a)
ILL. PLAY!
Alarm message in video monitor screen Description/action
VIDEO INPUT SIGNAL DOES NOT
MATCH SYSTEM SETUP.
ENCODING DOES NOT SYNCHRONIZE
WITH REF VIDEO.
INPUT VIDEO SIGNAL DOES NOT
SYNCHRONIZE WITH REF VIDEO
SIGNAL.
USE COMMON REFERENCE SIGNAL
OR CONNECT RECORDER REF OUT TO
PLAYER REF IN.
MEMORY FULL !!
DISC ERROR DETECTED.
NOW RECORDING ...
CACHE FULL.
DATA IS BEING OVERWRITTEN.
EDITING ACROSS MULTIPLE CLIPS IS
NOT POSSIBLE.
DISC FULL.
FOR MORE RECORDING, DELETE
SOME CLIPS.
REC MODE SELECTION DIFFERENT
FROM AUDIO/VIDEO ON DISC.
MATCH REC MODE SELECTION WITH
CLIP.
PREROLL TIME SETTING IS SHORT.
ASSEMBLE EDITING IS NOT POSSIBLE
BESIDES LAST CLIP.
CANNOT EDIT AV MATERIAL IN LIVE
LOGGING MODE.
Alarm message in monitor video
section
ILLEGAL PLAYBACK.
This appears when the signal that does not
correspond to the system frequency or the number of
lines set in this unit is being input, or when HDSDI or
i.LINK TS is selected as a video input signal while
setting the SD signal recording.
Input a signal that matches the system frequency, or
change this unit's system frequency setting (see
page 43).
Check the signals being input to this unit.
Input a reference signal synchronized with this unit's
system frequency.
Check the disc being recorded by this unit.
This appears when an error is found in the signal
recorded on the disc while performing the recording
verification function. Change the disc.
Wait for recording to finish.
This appears when the memory becomes full while
performing the disc exchange cache function.
Change the disc immediately.
This appears when an edit across multiple clips is
attempted.
It is not possible to edit across multiple clips.
This appears when the free capacity of the disc is
exhausted during assemble editing.
Delete unneeded clips, or exchange the disc for one
with enough free capacity.
This appears when editing of mixed recording formats
is enabled and an attempt is made to edit an
underlying clip in a different recording format.
Reset the recording format to match the format of the
editing target clip (see page 61).
This appears when editing is impossible because the
preroll time is too short.
Set setup menu item 001 PREROLL TIME to 5
seconds or longer.
This appears when an attempt is made to perform an
assemble edit on a clip that is not the last clip on the
disc.
Assemble editing is possible only on the last clip.
This appears when an edit preset command is
received while the Live Logging function is enabled.
Description/action
Check the disc being played by this unit.
167
Troubleshooting