Sony PDW-F1600 Operation Manual page 169

Alarm message in GUI
screen
A File with the Name you
Specified Already Exists.
Specify a Different Name.
Set NAMING FORM to "free" This appears when an attempt is made to change the clip name using Set Clip Name even
"No Flash Drive"
Not Loaded.
Syntax Error!
Irregular Disc is Used.
Use Professional Disc.
The Disc Write Protect TAB
is set to Save.
The REC Inhibit Mode is
Selected.
Check Function Menu.
Auto Formatting was not
Completed.
Video Resolution Differ from
it on Clip List.
No Clip Meets the Condition. This appears when no clip is found to meet clip filtering conditions.
Alarms relating to audio and video signals
Alarm message in time Alarm message in video monitor screen Action
data display area
a) INPUT VIDEO IS NOT DETECTED.
No INPUT!
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
a) INPUT AUDIO EMPHASIS IS NOT
EMPHASIS!
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on".
Description/action
This appears when an attempt is made to set an existing clip name while changing the clip name
using Set Clip Name.
though NAMING FORM is not set to "free" (see page 111).
This appears when an attempt is made to select "USB Flash Drive" in the media selection
screen under Load Planning Metadata/Select Drive even though the USB memory is not
connected.
This appears when a command related to planning metadata is executed with no planning
metadata loaded.
Load planning metadata and try again.
This appears when loading of planning metadata fails because of a syntax error. Correct the
syntax error and try loading the metadata again.
This appears when the unit is unable to record or play the inserted disc.
This unit can record and play Professional Discs. Insert a Professional Disc.
This appears when an attempt is made to format a write-protected disc.
Try formatting the disc after moving the write protect tab away from the Save position.
This appears when an attempt was made to format when function menu item HOME >F3: REC
INH is set to "ON".
Set F3: REC INH to "OFF" and try formatting again.
This appears when auto formatting fails.
This appears when an attempt is made to add a clip to a clip list containing clips with a different
video resolution (number of system lines).
It is not possible to add clips to clip lists containing clips with a different video resolution.
• Check the setting of V INPUT on Page P1 VIDEO of
the function menu (see page 49).
• Input an HDSDI signal.
Check the emphasis of the audio input signal.
Input a standard signal.
169
Troubleshooting