Sony PDW-F1600 Operation Manual page 133

Item number Item name
150 REC MODE
151 GUI OPERATION
153 FIND MODE
154 SINGLE CLIP PLAY MODE
a) The disc is ejected after recording stops.
Item number Item name
201 PARA RUN
212 VIDEO REMOTE CONTROL
a)
SELECT
214 REMOTE INTERFACE
215
i.LINK MODE
257 NETWORK ENABLE
Menu items in the 100s, relating to the control panels
Settings
Select the recording mode.
normal: Normal recording mode
D.EXC (disc exchange cache): Disc Exchange Cache mode
C.REC (clip continuous rec): Clip Continuous Rec mode
Select whether to disable the display of the Thumbnail Menu and Disc
Menu when this unit is in any mode other than stop mode.
ena(enable): Do not disable.
stop(via stop): Enable the display of menus in the stop mode.
dis(disable): Disable.
Specify the frame to be cued up when the PREV or NEXT button is
pressed.
clip: The first frame of the clip
R.ST (clip & rec start mark): The frame where a Rec Start essence
mark is set (if no essence mark is set, the first frame of the clip)
SHOTMARK1: Shot Mark1
Put the unit into single clip playback mode, or exit from single clip
playback mode.
off: Exits from single clip playback mode. (Puts the unit into continuous
playback mode.)
on: Puts the unit into single clip playback mode.
Menu items in the 200s, relating to the remote control interface
Settings
Select whether to use synchronized operation for two or more VTRs.
dis (disable): No synchronized operationena
ena (enable): Use synchronized operation
Note
To use synchronized operation for two or more VTRs, set item 201 to ena
on all of the VTRs.
Select whether to control the up converter or down converter when
controlling the image enhancer from the HKDV-900 or another unit
connected to the VIDEO CONTROL connector.
down: Control the down-converter.
up: Control the up-converter.
u&d: Control both the up- and down-converter.
Note
It is also possible to adjust setup menu item 718 SETUP LEVEL/BLACK
LEVEL from the HKDV-900. Hold down the D2 button on the HKDV-900
and rotate the SETUP dial.
When the remote control switch is set to REMOTE, select the device from
which to remote-control this unit.
9PIN: Device connected to the REMOTE(9P) connector.
SDI: Device connected to the SD/HDSDI INPUT connector.
i.LINK: Device connected to the
b)
Select the connection method for the
FAM (FAM (PC REMOTE)): FAM connection
TS: TS connection
Select the remote control switch positions which enable network
connections.
net (network): Only when the switch is set to "NET".
n&9P (network & remote(9PIN)): When the switch is set to "NET", and
when the switch is set to "REMOTE" and setup menu item 214 is set
to "9PIN".
b) The unit enters stop mode when the PLAY button is pressed. It enters
freeze picture mode (jog, shuttle, or variable mode) when the SHTL/JOG
button or VAR/JOG button is pressed.
(i.LINK) S400 connector.
(i.LINK) S400 connector.
c)
b)
133
Setup Menu