Sony PDW-F1600 Operation Manual page 59

system to perform a full salvage of the disc. As the other
system, use the PDW-F800 or PDW-700.
• The following alarm message (see page 162) may
appear when you insert a disc:
"DISC CANNOT BE RECORDED. FORMAT DISC
OR CONTACT SERVICE TO RUN CLIP SALVAGE
PROGRAM. (XXXX)"
This message means that recording on that disc did not
end normally. The "XXXX" in the message is a code for
XDCAM devices that can salvage the disc. Refer to the
following table and use one of the indicated devices to
salvage the disc.
Code (XXXX) Model
0002 PDW-1500/530/510/R1
PDW-F70/F350/F330
0200 PDW-F70/F350/F330 (Version 1.9 or
higher)
PDW-F75/F355/F335
a) PDW-HD1500/HR1/700
0300
a) PDW-HD1500/700 (Version 1.5 or higher)
0301
PDW-F1600/F800
a)Does not appear on this unit.
• Even when these functions are used, it is not possible to
recover data from immediately before the interruption of
recording. The amount of data lost is as follows.
Quick salvage: From 2 to 4 seconds of data before the
interruption of recording.
Full salvage: From 4 to 6 seconds of data before the
interruption of recording.
(More data may be lost when the unit is subject to
vibrations, and when you switch frequently between
recording and paused.)
• You are prompted to execute a full salvage every time
you insert a disc that has not been salvaged, or power the
unit on with such as disc loaded.
• No recording is possible on discs containing clips that
have not been salvaged, although it is possible to play
back the normally recorded sections. Recording
becomes possible if you perform a quick format, but this
erases all of the original recorded content.
To restore clips with a full salvage
1
Insert the disc on which recording did not end
normally.
The message "Salvage ?" appears on the display.
To cancel the clip salvage
Press the RESET/RETURN button.
Notes
• The message "EJECT?" appears when "REC INHI"
is displayed. If the disc is write protected, eject the
disc, set the Write Inhibit tab to enable recording,
and then insert the disc again. If REC INH on
HOME page of the function menu is set to "ON", set
it to "OFF" (see page 48).
• This operation cannot be cancelled once it begins.
2
Press the PUSH SET(S.SEL) knob.
Processing begins and the message "Executing."
appears.
When processing finishes, a message appears to
display the results.
If the message reads "Incomplete!", the clips that
failed were lost.
59
Recording