Canon PIXMA MX320 Manual page 606

Summary of Reports and Lists
#018 Line was busy.
#022 Try again.
#037
Memory is full.
Transmission has been
#059
canceled due to a fax
information mismatch.
#085 Try again in black & white
transmission.
STOP The Stop button was
pressed during
transmission.
RX Report
This machine can print a RX (reception) report after receiving a document, confirming whether the
reception has been completed successfully. At the time of purchase, the machine is set so that RX
reports are not printed at all. You can set the machine to print a report each time it receives a
document, or only when an error occurs.
Note
For details on the RX report settings, see
For the errors when you receive a fax, see
Errors when you receive a fax
If an error occurs when you receive a fax, the error number is printed in the RX report (there are
some errors for which the cause is also printed).
The causes corresponding to the error numbers are as follows.
No.
#003 It takes too long to receive a
page.
#005 No answer.
#037 Memory is full.
Dial tone detect in Transmission settings is set
to ON. Set it to OFF, then send the fax.
The fax/telephone number you dialed is busy.
Try dialing again after waiting for a moment.
The fax/telephone number registered to coded
speed dial is incorrect.
Check the recipient's fax/telephone number,
correct the fax/telephone number registered to
the coded speed dial code, then send the
document again.
The machine could not send a document
because its memory is full.
Resend the document after deleting contents
in memory. See
.
Memory
Transmission has been canceled because the
machine could not detect the recipient's fax
machine information or the information did not
match the dialed number. This error number is
displayed when Check RX fax info is set to ON.
For details, see
Information (Checking the Recipient's
Information)
The recipient's fax machine is not color-
compatible.
Resend the document in black & white.
The Stop button was pressed to cancel
transmission of the document. Resend it if
necessary.
RX report .
Errors when you receive a fax
Cause
Contact the sender and have the sender divide
the fax or set the image quality (Fax resolution)
to a lower setting and resend it.
When receiving a fax manually, the machine
could not detect the signals from the sender's
fax machine.
Contact the sender and have the sender
resend it, or set the machine to receive the fax
automatically.
The machine could not receive a fax because
its memory is full.
Delete contents in memory, then ask the
sender to resend the fax. See
Document in Memory
Deleting a Document in
Sending Faxes after Checking
.
.
Action
Deleting a
.
Page 606 of 817 pages