Table of Contents
Advertisement
Replacing the Subcassette
Replacing the
Subcassette
Feed roller A
3-6
The ribbon can be replaced up to five times before the entire ribbon
cassette itself must be replaced.
Notice:
A Fujitsu ribbon cassette is recommended. Other cassettes may cause
operating problems or damage the print head. Fujitsu takes no
responsibility for print head faults caused by such cassettes. Replace the
cassette carefully to avoid getting ink on your hands.
Replace the ribbon as follows:
1. Turn off printer power ( ).
2. Remove the ribbon cassette from the printer as explained in
"Removing the Ribbon Cassette" on page 3-5.
3. Sequentially press each of the four lock tabs A in the directions of
the arrows, starting from either end. Then open the cassette lid.
Lid
4. Press feed roller A in the direction of the arrow until it clicks into
place. This procedure loosens the ribbon holder.
5. Lift the reverse guide and remove the old ribbon.
Lock tabs A
Reverse guide
User's Manual
Advertisement
Table of Contents
