Table of Contents
Advertisement
<<FUNCTION>>
SAVE&END
MENU1
MENU2
V-ALMNT
GAP-ADJ
Resetting
Default Values
User's Manual
Important:
The only way to exit setup mode without saving changes is to turn off
the printer. Turning the printer back on activates the previous default
settings.
To exit setup mode and save changes using SELF-TST, see "Test
Printing (SELF-TST)" on page 8-38. To exit setup mode and save
changes using SAVE&END, do the following:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on the
page. If it is not printed, press ONLINE to print it. If using SELF-
TST or HEX-DUMP, press LOCK instead of ONLINE.
HARDWRE
ADJUST
CONFIG
(GAP-ADJ is printed only with APTC installed.)
2. Select SAVE&END.
Check that the yellow arrow on the print head is positioned beneath
SAVE&END. Press FONT or MENU to select SAVE&END. The
printer exits setup mode and goes back online (the ONLINE
indicator glows green). Any changes made in setup mode are saved.
When resetting the printers default values, default values set at
shipment or default values for MENU1 and MENU2 set at shipment
make sure to reset as described in the following sections.
1. Default values
Default values activated when power is turned on are saved in the
printer's permanent memory. The easiest way to reset them is to
turn the printer off and then on. This procedure eliminates changes
not to be saved.
2. Default values set at shipment
For a list of the default values set at shipment, see "Printing a List
of Options" on page 8-8. To reset the default values for all
functions, do the following:
Resetting Default Values
DEFAULT
LIST
SELF-TST
HEX-DUMP
SETUP MODE
8-37
Advertisement
Table of Contents
