Table of Contents
Advertisement
User's Manual
4. Binding holes in the scanning area of the sensor
The shaded area shown in the figure indicates the scanning area of
the sensor in which binding holes may lie. Their size is subject to
the following restrictions as described and illustrated.
Any binding hole completely in the shaded area must be 7 mm
(0.28 in) or less in diameter.
Caution:
Always avoid printing on the binding holes. This could damage the
print head.
30 mm
(1.2 in)
10 mm (0.4 in)
First character
Binding holes
5. Perforations
The perforations in continuous forms must meet the following
conditions:
The ratio of cut to uncut areas for single-part continuous forms
must be 3:1.
Continuous Forms
PAPER
SPECIFICATIONS
7-5
Advertisement
Table of Contents
