Changing Print Adjustment Options - Fujitsu DL6400Pro User Manual

Changing Print Adjustment Options

Changing Print
Adjustment
Options
8-28
4. Repeat step (3) until all required options are changed.
5. Exit HARDWRE.
Press ONLINE to exit the HARDWRE function and reprint the
<<FUNCTION>> menu.
6. Either select another function or exit setup mode, saving changes.
To exit setup mode and save changes, check that the yellow arrow
on the print head is positioned beneath SAVE&END. Then press
FONT or MENU.
When printing using ruled paper, use ADJUST to adjust the print
position so the printout fits the ruled lines. Use ADJUST to do the
following:
• Set the top-of-form.
• Fine-adjust the top-of-form.
• Fine-adjust the left print start column (left margin).
• Adjust for cumulative line-spacing errors on a page.
For the first three tasks ADJUST provides separate items for cut sheets
and continuous forms. The last task applies to cut sheets only.
The top edge of paper is the physical top of the page. The logical top
of the page, as understood by the printer when loading paper, is called
its top-of-form, where printing starts. Printing actually starts at the
position obtained by adding the following:
Top-of-form; default value = 1 inch (25.4 mm)
Top margin specified by software
Printer's <TOP-MRG> (top margin) setting; default value = 1 line
Table 8-5 lists ADJUST items and options in the order they are
printed. The procedure for changing the top-of-form follows Table
8-5.
User's Manual