Table of Contents
Advertisement
PAPER HANDLING
3-6
2. If necessary, reset the paper thickness lever. (See the section
Adjusting for Paper Thickness earlier in this chapter.)
3. Move the paper select lever forward. (This lever is at the top
left of the printer.)
4. Raise the cut sheet stand. Position the left paper guide. Note
that its movable range is limited.
Adjusting the left margin
Below the left paper guide, the cut sheet stand has a scale graduated in
units of 0.1 inch. When the left paper guide is positioned all the way to
the right, the left margin is 5 mm (0.2 inch). To help align paper, also
use the two inch-based rulers on the separator of the printer. The
gradations on the ruler are for 10 columns per inch.
Left margin
(minimum)
Preparing to load a sheet of paper
5. Insert a sheet of paper into the cut sheet stand. Make sure that
the bottom edge of the paper engages snugly with the platen.
Adjust the right paper guide.
User's Manual
Advertisement
Table of Contents
