Fujitsu DL3800 User Manual page 48

SETTING UP
2-26
4. Use your software printer selection menus or the printer setup
mode (described in Chapter 5) to make required changes in the
page layout or other print features.
If the printer does not print or prints the wrong characters,
proceed as follows:
• Make sure that the interface cable is properly connected.
• Make sure that the printer emulation selected in your
software is the same as that selected on the printer.
• If you are using a serial interface, make sure that the printer
serial interface settings are the same as those on the compu-
ter. The printer's preselected factory settings are 8 data bits,
no parity, 1 stop bit, 9600 baud, and XON/XOFF protocol.
You can change the serial settings on either the printer or
your computer. To change the printer settings, see Chapter
5. To change the computer settings, use the selection menus
provided by your software or the commands of your
computer operating system. The following example uses the
MS-DOS operating system:
User's Manual