Fujitsu DL3800 User Manual page 123

User's Manual
Table 5.5 ADJUST Items and Options
NOTE: Underlined options are the factory defaults.
ADJUST
Options
Items
<CNT-ORG>
1/6 IN
:
6/6 IN
:
66/6 IN
<CNTFINE>
0/180, ..., 29/180 Increases top-of-form in
<CUT-ORG>
1/6 IN
:
6/6 IN
:
66/6 IN
<CUTFINE>
0/180, ..., 29/180 Increases top-of-form in
USING SETUP MODE
Description
Sets the top-of-form for continu-
ous forms in increments of 1/6
inch (4.2 mm) from the physical
top of the page.
The default is recommended if
your top margin is not software-
specified. A setting of 1/6 inch
is preferable when your top
margin is software-specified.
Fine-tunes the top-of-form
position for continuous forms.
increments of 1/180 inch
(0.14 mm).
Sets the top-of-form for single
sheets in increments of 1/6 inch
(4.2 mm) from the physical top
of the page.
The default is recommended if
your top margin is not software-
specified. A setting of 1/6 inch
is preferable when your top
margin is software-specified.
Fine-tunes the top-of-form
position for single sheets.
increments of 1/180 inch
(0.14 mm).
5-35