Table of Contents
Advertisement
Defaults
Dot matrix
Downloading
dpi
Emulation
Font
Form feed (FF)
Graphics printing
Hexadecimal
Hex dump
User's Manual
Settings selected automatically by the printer when power is
turned on. Enter setup mode to change the defaults to ensure
compatibility with your system hardware and software.
The grid used to print characters on a dot matrix printer. Each
dot corresponds to a wire in the print head.
Transferring soft fonts from the computer to the printer's
memory. Downloading allows you to use fonts not resident in
the computer.
Dots per inch.
A command set that allows one printer to print like another
printer. This printer has three resident emulations: Fujitsu
DPL24C PLUS (native command set), IBM proprinter XL24E,
and Epson ESC/P2.
A complete set of printable characters having the same size
and style. For example, Courier 10 and Prestige Elite 12 are
commonly used fonts.
A signal to the printer to advance the paper forward one page.
Form feeds can be executed either by your software or by
holding down the LF/FF button on the printer control panel.
Controlling the print head wires (dots) individually to produce
a picture or an image on the page.
A base-16 numbering system (also commonly referred to as
hex numbers). Since a base-16 system requires 16 digits,
numbers 0 through 9 and letters A through F are used.
Expressing binary numbers in hexadecimal uses fewer digits.
A hexadecimal printout of control codes and data. Hex dumps
are used to debug computer programs and to troubleshoot
printer malfunctions. To print a hex dump on the printer, use
the HEX-DUMP function in setup mode.
GLOSSARY OF TERMS
GL-3
Advertisement
Table of Contents
