Table of Contents
Advertisement
TESTING THE PRINTER
(OFFLINE)
User's Manual
At this point, load paper and run the printer self-test. The self-test
checks printer performance and print quality before you connect the
printer to the computer. Use either single sheets or continuous forms
(see Chapter 3). This section describes the self-test procedure using
single sheets.
Loading Paper for the Self-Test
To print the self-test, use paper wider than 215.9 mm (8.5 inches) and
set the left paper guide all the way to the right to avoid clipping the test
pattern. Standard letter or A4 size paper can be used lengthwise
(portrait mode).
Before loading paper, make sure that the printer is on. Then, proceed
as follows:
1. Make sure that the paper thickness lever (located on the top
right of the printer) is at position 1. Make sure that the paper
select lever (located on the top left of the printer) is set to the
front, as shown below.
Loading a sheet of paper
SETTING UP
2-13
Advertisement
Table of Contents
