Table of Contents
Advertisement
SETTING UP
2-12
To plug in the power cord:
1. Plug one end of the power cord into the power connector on the
rear of the printer.
2. Plug the other end of the power cord into the power outlet.
Connecting the power cord
3. Make sure that the power cord is securely connected.
4. Turn on the power by pressing the side marked "1" on the
power switch. Within a few seconds, the MENU1 indicator on
the printer control panel will light, the print head will move to
its home position, and the ONLINE indicator will light (green).
NOTE
If no forms are loaded, the printer may beep and the red PAPER OUT
indicator may light and the ONLINE indicator will not light if the
paper select lever is set backward to the continuous forms position.
Move the paper select lever forward to the single sheet position (as
described in the next section). The PAPER OUT indicator will go out.
This condition is a result of the factory default settings and poses no
problem.
User's Manual
Advertisement
Table of Contents
