Removing The Hinge Covers; Replacing The Hinge Covers - Dell Precision M2400 Service Manual

Back to Contents Page
Hinge Covers
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Hinge Covers
Replacing the Hinge Covers
Removing the Hinge Covers
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
The hinge covers are not interchangeable; the left one covers the DisplayPort connector and the right one covers the RJ-45 network connector.
1. Follow the procedures in Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the M2.5 x 5-mm screw from each hinge cover.
4. Slide each hinge cover forward and lift to remove it.
1 M2.5 x 5-mm screws (2) 2 hinge covers
Replacing the Hinge Covers
1. Slide the left hinge cover over the DisplayPort connector and slide the right hinge cover over the RJ-45 network connector.
2. Replace the M2.5x5-mm screw in each hinge cover.
3. Replace the bottom of the base assembly (see
4. Follow the procedures in After Working on Your
Back to Contents Page
Computer.
Removing the Bottom of the Base
Replacing the Bottom of the Base
Computer.
Assembly).
Assembly).