6. Remove the four M2.5 x 5-mm screws from the display panel.
7. Lift the display panel out of the display cover and carefully lay the display panel flat on your workspace. Be careful to avoid damaging the display panel
with the hinges and cables on the display cover.
8. Disconnect the inverter backlight cable from the inverter.
1 M2.5 x 5-mm screws (4) 2 display panel
3 display cover
4 inverter backlight cable
9. Disconnect the display cable. Squeeze the release tabs together, then pull the cable out of the connector.
1 underside of display panel 2 display cable
3 connector release tabs
4 display cable connector
10. Remove four M2 x 3-mm screws from the right bracket and four M2 x 3- mm screws from the left bracket.