Replacing The Camera And Microphone Assembly - Dell Precision M2400 Service Manual

5 camera/microphone cable
Replacing the Camera and Microphone Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Slide the cable connector of the camera/microphone cable into the connector on the camera/microphone assembly.
2. Close the lever on the connector on the camera/microphone assembly.
3. Angle in and align the camera/microphone assembly with the notch on the display cover.
1 camera/microphone assembly 2 notch on display cover
4. Tighten the M2 x 3-mm screw that secures the camera/microphone assembly to the display cover.
5. Replace the display bezel (see
6. Replace the display assembly (see
7. Replace the hinge covers (see
8. Replace the bottom of the base assembly (see
9. Follow the procedures in After Working on Your
Removing the Latch Hook Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the hinge covers (see
4. Remove the display assembly (see
5. Remove the display bezel (see
6. Remove the M2.5 x 5-mm screw, and angle the latch hook assembly out of the display cover.
Replacing the Display Bezel (E6400 and M2400)
Replacing the Display Assembly (E6400 and M2400)
Replacing the Hinge Covers).
Replacing the Bottom of the Base
Computer.
Computer.
Removing the Bottom of the Base
Removing the Hinge Covers).
Removing the Display Assembly (E6400 and M2400)
Removing the Display Bezel (E6400 and M2400)
or Replacing the Display Bezel (E6400
or Replacing the Display Bezel (E6400
Assembly).
Assembly).
or Removing the Display Assembly (E6400
or Removing the Display Bezel (E6400
ATG)).
ATG)).
ATG)).
ATG)).