Removing The Card Cage; Replacing The Card Cage - Dell Precision M2400 Service Manual

Back to Contents Page
Card Cage
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Card Cage
Replacing the Card Cage
Removing the Card Cage
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the modular drive (see
4. Remove the hinge covers (see
5. Remove the heatsink assembly (see
6. Remove the display assembly (see
7. Remove the LED cover (see
8. Remove the keyboard (see
9. Remove the right speaker grill (see
10. Remove the palm rest assembly
11. If a card is in the card cage, remove the card.
12. Remove the two M2 x 3 screws.
13. Press down on the connector-end of the card cage, then grasp each side of the card cage and push it towards the back of the laptop.
14. Pivot the card cage up to a 45-degree angle, then lift it up from the connector and laptop.
1 M2 x 3 screws (2) 2 card cage
3 connector
Replacing the Card Cage
Computer.
Removing the Bottom of the Base
Removing the Modular Drive).
Removing the Hinge Covers).
Removing the Processor Heatsink
Removing the Display Assembly (E6400 and M2400)
Removing the LED Cover).
Removing the Keyboard).
Removing the Right Speaker Grill/Fingerprint Reader
(Removing the Palm Rest Assembly).
Assembly).
Assembly).
or Removing the Display Assembly (E6400
Assembly).
ATG)).