1 notch on display cover 2 microphone board
4. Tighten the M2 x 3-mm screw that secures the microphone board to the display cover.
5. Replace the display bezel (see
6. Replace the display assembly (see
7. Replace the hinge covers (see
8. Replace the bottom of the base assembly (see
9. Follow the procedures in
After Working on Your
Removing the Camera and Microphone Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in
Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the hinge covers (see
4. Remove the display assembly (see
5. Remove the display bezel (see
6. Lift the small connector lever on the camera/microphone cable.
7. Loosen the captive screw, and carefully lift the camera/microphone assembly up at an angle and disconnect the camera/microphone cable.
1 display cover
2 camera/microphone assembly
3 captive screw
4 connector lever
Replacing the Display Bezel (E6400 and M2400)
Replacing the Display Assembly (E6400 and M2400)
Replacing the Hinge
Covers).
Replacing the Bottom of the Base
Computer.
Computer.
Removing the Bottom of the Base
Removing the Hinge
Covers).
Removing the Display Assembly (E6400 and M2400)
Removing the Display Bezel (E6400 and M2400)
or
Replacing the Display Bezel (E6400
or
Replacing the Display Bezel (E6400
Assembly).
Assembly).
or
Removing the Display Assembly (E6400
or
Removing the Display Bezel (E6400
ATG)).
ATG)).
ATG)).
ATG)).