Dell Precision M2400 Service Manual page 34

1 display panel 2 brackets (2)
3 M2 x 3-mm screws (8)
Replacing the CCFL Display Panel and Brackets (E6400 and M2400)
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE: The brackets are labeled "L" (left) and "R" (right).
1. Replace the four M2 x 3-mm screws on the right bracket and the four
M2 x 3-mm screws on the left bracket.
2. Place the display panel upside down on your workspace in front of the display cover.
3. Connect the backlight cable to the inverter.
4. Connect the display cable to the connector on the back of the display panel.
5. Place the display panel in display cover. Use the alignment posts in the display cover to align each bracket.
6. Replace the four M2.5 x 5-mm screws that secure the display panel to the display cover.
7. Replace the display bezel (see
8. Replace the display assembly (see
9. Replace the hinge covers (see
10. Replace the bottom of the base assembly (see
11. Follow the procedures in After Working on Your
Removing the LED Display Panel and Brackets (E6400 and M2400)
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the hinge covers (see
4. Remove the display assembly (see
5. Remove the display bezel (see
Replacing the Display Bezel (E6400 and
Replacing the Display Assembly (E6400 and
Replacing the Hinge Covers).
Replacing the Bottom of the Base
Computer.
Computer.
Removing the Bottom of the Base
Removing the Hinge Covers).
Removing the Display Assembly (E6400 and
Removing the Display Bezel (E6400 and
M2400)).
M2400)).
Assembly).
Assembly).
M2400)).
M2400)).