Dell Latitude E4200 System Board Replacement
Dell laptop system board replacement
Hide thumbs
Also See for Latitude E4200:
- User manual (124 pages) ,
- Service manual (74 pages) ,
- How-to manual (46 pages)
Advertisement
Replacing the System Board
About Warnings
WARNING:
or death.
Setting the AMT Manageability Mode
NOTE:
For Dell™ Latitude™ E5400 and E5500 computers, and for Dell Precision™
M6400 Mobile Workstations, skip this section and see "Programming the Service Tag"
on page 3.
WARNING:
information that shipped with your computer. For additional safety best practices,
see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
AC adapter and modem cables from all electrical outlets.
CAUTION:
Follow the instructions carefully to ensure that you configure the
computer for the correct management mode.
1 Remove the bottom access panel (see your Service Manual).
2 Take note of the label that is attached to the inside of the bottom access panel.
March 2009
A WARNING indicates a potential for property damage, personal injury,
Before you begin any of the procedures in this section, read the safety
If you need to remove the bottom access panel, first disconnect the
label
label
Advertisement
Related Manuals for Dell Latitude E4200
Summary of Contents for Dell Latitude E4200
-
Page 1: Replacing The System Board
A WARNING indicates a potential for property damage, personal injury, or death. Setting the AMT Manageability Mode NOTE: For Dell™ Latitude™ E5400 and E5500 computers, and for Dell Precision™ M6400 Mobile Workstations, skip this section and see "Programming the Service Tag" on page 3. WARNING: Before you begin any of the procedures in this section, read the safety information that shipped with your computer. - Page 2 You should see one of the following four configuration-mode labels on the inside of the chassis: NOTE: If the original configuration-mode label is missing, damaged, or otherwise illegible, contact Dell to obtain your configuration-mode number (see your computer documentation for contact information). 3 Replace the bottom access panel. NOTE: For information on replacing the system board, see "Replacing the System...
-
Page 3: Programming The Service Tag
Programming the Service Tag After replacing the system board for Latitude E5400, E5500, and Dell Precision M6400 Mobile Workstations, you need to program the service tag if the following message is displayed on startup: WARNING: The Service Tag has not been programmed. - Page 4 Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, Latitude, Dell Precision, and the DELL logo are trademarks of Dell Inc.; iAMT is a registered trademark of Intel Corporation in the U.S. and other countries; Microsoft, Windows...