Replacing the 1394 Card
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Insert the 1394 card at a 45-degree angle to fit the connector into the base assembly. Use the alignment pins to seat into position.
2. Replace the two M2 x 3 screws.
3. Route and connect the 1394 cable to the system board.
4. Replace the card cage (see
5. Replace the palm rest assembly
6. Replace the right speaker grill (see
7. Replace the keyboard (see
8. Replace the LED cover (see
9. Replace the display assembly (see
10. Replace the heatsink assembly (see
11. Replace the hinge covers (see
12. Replace the modular drive (see
13. Replace the bottom of the base assembly (see
14. Follow the procedures in
After Working on Your
Back to Contents Page
Replacing the Card
Cage).
(Replacing the Palm Rest
Assembly).
Replacing the Right Speaker Grill/Fingerprint Reader
Replacing the
Keyboard).
Replacing the LED
Cover).
Replacing the Display Assembly (E6400 and M2400)
Replacing the Processor Heatsink
Replacing the Hinge
Covers).
Replacing the Modular
Drive).
Replacing the Bottom of the Base
Computer.
Assembly).
or
Replacing the Display Assembly (E6400
Assembly).
Assembly).
ATG)).