Removing The Base Assembly - Dell Precision M2400 Service Manual

Back to Contents Page
Base Assembly
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Bottom of the Base Assembly
Replacing the Bottom of the Base Assembly
Removing the Base Assembly
Replacing the Base Assembly
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
Removing the Bottom of the Base Assembly
1. Follow the procedures in Before Working on Your
2. Close the display and turn the computer upside down.
3. Loosen the captive screw.
4. Slide the bottom of the base assembly away from the hinge covers, and lift to remove the bottom of the base assembly.
1 hinges covers (2) 2 bottom of the base assembly
3 captive screw
Replacing the Bottom of the Base Assembly
1. Slide the bottom of the base assembly into place.
2. Tighten the captive screw.
3. Follow the procedures in After Working on Your
Removing the Base Assembly
1. Follow the procedures in Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the card in the WWAN/FCM card slot, if present (see
4. Remove the card from the WLAN/WiMax card slot, if present (see
Computer.
Computer.
Computer.
Removing the Bottom of the Base
Removing a WWAN Card
Removing the WLAN/WiMax
Assembly).
or Removing an FCM from the WWAN/FCM
Card).
Slot).