Table of Contents
Advertisement
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
High-performance fan option
This kit is available to meet some extended ambient operating temperatures above 35 degrees Celsius.
For more information about the qualifications for extended ambient configurations, see the Hewlett
Packard Enterprise website (http://www.hpe.com/servers/ASHRAE).
To install the component:
1.
Power down the server (on page 21).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 21).
o
Remove the server from the rack (on page 22).
4.
Remove the access panel (on page 22).
IMPORTANT: Do not mix standard fans and high-performance fans in the same server.
Hardware options installation 33
Advertisement
Table of Contents
