Completing The Parts Replacement; Reinstalling The Server Cover And Reconnecting Cables - Lenovo ThinkServer TS430 User Manual

6. Remove the old system board battery.
Figure 105. Removing the system board battery
7. Install a new system board battery.
Figure 106. Installing the system board battery
8. Reinstall the PCI card that has been removed. See "Installing a PCI card" on page 98.
9. Dispose of the old system board battery as required by local ordinances or regulations.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 170. After you replace
the system board battery, you must reset passwords, reset system date and time, and reconfigure the
server. See Chapter 5 "Configuring the server" on page 57.

Completing the parts replacement

This topic provides instructions to help you complete the parts replacement and turn on your server.
To complete the parts replacement, you must properly route the cables inside the server, reinstall the server
cover, reconnect all the external cables and, for some devices, update the firmware and run the Setup Utility
program to do further setup.

Reinstalling the server cover and reconnecting cables

Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 85.
This topic provides instructions on how to reinstall the server cover and reconnect cables to your server.
Attention: For proper cooling and airflow, reinstall the server cover before turning on the server. Operating
the server for extended periods of time (more than 30 minutes) with the server cover removed might
damage server components.
170
ThinkServer TS430 User Guide