8. Remove the four screws
front of the power distribution board and cage assembly. Then, push the power distribution board and
cage assembly from the rear until it is released from the metal retaining tab
it out of the chassis.
Figure 90. Removing the power distribution board and cage assembly
9. Touch the static-protective package that contains the new power distribution board and cage assembly
to any unpainted surface on the outside of the server. Then, remove the new power distribution board
and cage assembly from the package.
1
at the rear of the chassis and the two screws
2
.
Chapter 6
Installing, removing, or replacing hardware
on the metal clip at the
3
and then carefully lift
153