Table of Contents
Advertisement
User Manual
DMALogStatus
A.7.12
1 simnow> sledgenb.usage
Automation Command
LogHT (0|1)
HTLogStatus
LogPCIConfig (0|1)
PCILogStatus
GetConfig
ProductFile <FileName>
A.7.13
1 simnow> dbc.usage
Automation Command
GetParam
SetParam <size> <depth> <bits>
A.7.14
1 simnow> 8111.usage
Automation Command
BaseID (00|01)
GetBaseID
HtInterrupts (0|1)
HtIntStatus
IoLog (0|1)
IoLogStatus
MemLog (0|1)
MemLogStatus
SmiSciLog (0|1)
SmiSciLogStatus
Appendix A
AMD Confidential
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
th
8
Generation Northbridge
Enables (1) or disables (0) logging.
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
Enables (1) or disables (0) PCI Config logging.
Returns „enabled‟ if PCI Config logging is enabled
otherwise it returns „disabled‟.
Displays Northbridge logging configuration.
Loads the specified product file "FileName".
DBC
Returns disk block cache parameters (size, depth and
bits).
Sets disk block cache parameters.
AMD-8111™ Device
This specifies the HyperTransport™ protocol base unit
ID. The IC's logic uses this value to determine the unit
IDs for HyperTransport request and response packets.
The Base ID must be 00 or 01.
Returns the HyperTransport base unit ID (BUID).
Enables (1) or disables (0) HyperTransport interrupts.
Returns „enabled‟ if HyperTransport interrupts are
enabled; otherwise it returns „disabled‟.
Enables (1) or disables (0) IO logging.
Returns „enabled‟ if IO Logging is enabled; otherwise it
returns „disabled‟.
Enables (1) or disables (0) IO logging.
Returns „enabled‟ if Memory Logging is enabled;
otherwise it returns „disabled‟.
Enables (1) or disables (0) IO logging.
Returns „enabled‟ if SMI SCI Logging is enabled;
otherwise it returns „disabled‟.
September 12
Description
Description
Description
th
, 2008
239
Advertisement
Table of Contents
