Table of Contents
Advertisement
User Manual
Automation Command
InitValStatus
DisableCache < 0 | 1 >
GetCacheDisabled
GetConfig
FlashMode < 0 | 1 >
FlashUpdateFile < 0 | 1 >
ncHTMode < 0 | 1 >
ForceInitFile <filename>
GetCommandSequence
CommandSequence < 0 | 1 >
GetFlashMode
FlashMode < 0 | 1 >
A.7.23 Raid
1 simnow> raid.usage
Automation Command
Noise [ {enable|disable} ]
RomImage <File name>
SetVolume <Vol #> <Image file> [
<Journal file> ]
DeleteVolume <Vol #>
Sync
Type {5304|5312}
Image <Vol #> <Image file>
GetImage <Vol #>
Appendix A
AMD Confidential
Description
Displays information if the initializer is used and if the
memory initialization is activated.
Sets memory region to cacheable (0) or non-cacheable
(1).
Returns true if non-cacheable otherwise it returns false.
Displays Memory configuration information.
Enables (1) or disables (0) this device to be used as a
flash ROM.
Enables (1) or disbales (0) writes to the flash ROM to
update the ROM image.
Enables (1) or disables (0) decoding of HyperTransport
messages.
The ForceInitFile command allows the user to change
the BIOS ROM path once the simulation has already
started. This is legitimate only when the new BIOS
ROM is a byte-for-byte copy of the initial BIOS ROM
that simulation began with (i.e., same file, different
path).
Prints which of the two command sequences the flash
device is programmed to.
0-SST, 1-ATMEL. Allows to set the command sequence
to SST or ATMEL.
Tells you if the device is configured to act as a flash
memory.
Allows the user to set the memory device as flash
memory.
Description
Enable to print debug messages; otherwise disable.
Allows a boot ROM image to be supported - at the
moment the emulation does not work with any known
ROM images.
This was the original way to setup the image and journal
files - rather than having two separate commands.
Undoes the Image or Journal commands and puts the
volume back in an unintialized state.
This command flushes the in-memory caches out to the
files.
This was supposed to allow support for both the 5304
(default) and 5312 cards - the 5312 support is not well
tested.
Creates a volume for the give disk image (For e.g.,
raid.image 0 i:\c0d0.img).
Displays the disk image for the given volume.
th
September 12
, 2008
245
Advertisement
Table of Contents
