Table of Contents
Advertisement
User Manual
Click on the "Best Fit To Window" button ( ) to reduce or enlarge the size of the
simulated display area so that the entire simulated display area will fit into the simulators
main window. If you hold down the CTRL key when clicking on the "best fit" button, it
"locks" into a state where the simulated display area is resized whenever the simulated
graphics display resolution changes. To clear this locked condition, click on the "best fit"
button again.
3.2 Device Window
The Devices Window, shown in Figure 3-2, is opened by selecting "View→Show
Devices" or clicking on the
computer and modify its properties, BIOS images, memory characteristics, and attached
components.
This section describes the main components of the Device Window and shows how to
build up and configure a simulated computer. It explains the interface using some of the
most-often used simulation components. Please also see the walkthrough of building a
single-processor system in Section 6, "Create a Simulated Computer", on page 45.
Represents
Message Routing
Device List
Chapter 3: Graphical User Interface
AMD Confidential
button. In this window, you can create a simulated
Figure 3-2: Device Window
th
September 12
, 2008
Device
Window
System
Configuration
Workspace
9
Advertisement
Table of Contents
