Gas Conversion Components; Electrical Connections - Dean 24G Series Installation & Operation Manual

3.8 Gas Conversion Components

Use the following components to convert from natural gas to propane and vice-versa. See Section
3.6 for orifice quantities required for conversion.
Natural Gas to Propane Components
REF
810-2400
Burner orifice*
(See Tables on Pages 3-10 – 3-11)
New Rating Contact factory at time of
Plate
* Burner orifices listed on pages 3-10 – 3-11 are for fryers operating at altitudes of
2000 feet (610 meters) or less. For altitudes greater than 2000 feet (610 meters),
contact the factory for the correct orifice size.

3.9 Electrical Connections

The fryer when installed must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the appropriate National or European Community (CE) standards.
This fryer is equipped with a three-prong (grounding) plug for protection against
electrical shock and must be plugged directly into a properly grounded, three-prong
receptacle. DO NOT CUT, REMOVE, OR OTHERWISE BYPASS THE GROUNDING
The rating plate and wiring diagram are located inside the front door. The fryer is equipped with a
115VAC single-phase
(International/CE). Do not cut or remove the ground prong from the power cord plug. Do not
attempt to use the fryer during a power outage.
This appliance requires electrical power for operation. Place the gas control valve in
the OFF position in case of a prolonged power outage. Do not attempt to operate
24G SERIES FLATBOTTOM GAS FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
DESCRIPTION
Pilot orifice (16LP)
conversion.
PRONG ON THIS PLUG!
60-hertz (Non-CE),
this appliance during a power outage.
Propane To Natural Gas Components
REF
810-0811
Burner orifice*
(See Tables on Pages 3-10 – 3-11)
New Rating Contact factory at time of
Plate
DANGER
or 230VAC single-phase
DANGER
3-14
DESCRIPTION
Pilot orifice (26N)
conversion.
50-hertz system