Understanding Printer Messages - Fuji Xerox DocuPrint CP305 d User Manual

Understanding Printer Messages

The printer LCD panel displays messages describing the current state of the printer and indicates
possible printer problems you must resolve. This section describes messages, their meanings, and
how to clear the messages.
IMPORTANT:
• When an error code is displayed, the print data remaining on the printer and the information accumulated in
the memory of the printer are not secured.
Error-Code
010-317
010-397
016-404
016-405
016-500
016-501
016-502
016-520
016-521
016-522
016-523
016-524
016-527
016-737
016-738
016-741
016-744
016-750
016-753
016-755
016-757
016-758
016-759
016-786
016-790
016-791
016-799
016-930
016-931
024-910
024-911
235 Troubleshooting
What You Can Do
Turn off the printer and wait for 30 minutes. Open the front cover and make sure that the
fuser unit is fully installed.
Turn off the printer. Confirm that the fuser unit is correctly installed, and turn on the
printer. Contact customer support if this failure is repeated.
Contact your system administrator.
Turn off the printer, and turn it on again. Contact customer support if this failure is
repeated.
Contact your system administrator.
Turn off the printer, and turn it on again. Contact customer support if this failure is
repeated.
Press the button, or wait for 30 seconds for the printer to recover.
The account is not registered. Contact your system administrator.
The function cannot be used. Contact your system administrator.
Printable page limit is exceeded. Contact your system administrator.
Press the button, or wait for 30 seconds for the printer to recover. Check if the
network cable is connected properly. If there is no problem with the network cable,
contact server administrator.
Press the button, or wait for 30 seconds for the printer to recover.
Press the button to clear the message and cancel the current print job. Confirm the
configuration of the printer on the print driver.
The device is not supported. Remove it from the USB port.
The USB hub is not supported. Remove it from the USB port.
Reload the specified paper on the standard 250-sheet tray.
Reload the specified paper on the optional 250-sheet feeder.