Table of Contents
Advertisement
C
6. U
T
HAPTER
SING
Intel PBX-IP Media Gateway.
PBX-IP Media Gateway.
Uniden IP Phone.
TeleVantage Softphone.
See Appendix F, "Using the TeleVantage H.323 SoftPhone."
SIP Phone.
Aastra 480i or eyeBeam SIP softphone. See the next section for more
instructions.
This selection is used by system administrators to create a null
None.
station, which is a station without a physical phone.
4.
In
Call using
the phone. For more information, see "Using dialing services" on page 12-8.
5.
Enter the external station's phone number in
phone's IP address in
6.
Check
Stutter dial tone
by stuttering the dial tone when you first pick up.
7.
Check
Disconnect when idle
a call. If unchecked, TeleVantage provides a 10-15 second window of
internal dial tone after a call ends so that you can use the telephone
commands for other activities. However, when unchecked you may find that
you cannot place a new call from ViewPoint immediately after ending a call,
because TeleVantage still considers the station off-hook. Checking the
setting should solve that problem.
Note that if checked, the station will not return to dial tone after the other
party in a call hangs up.
V
W
ELE
ANTAGE
ITH A
Choose for stations connected to an Intel
Choose for H.323-based Uniden IP phones.
Choose for the TeleVantage H.323 Softphone.
Choose for any SIP-based IP phone, such as the Vertical
, select the dialing service used when the user places calls from
.
Address
to have the phone alert you to new voice messages
to disconnect calls immediately when you end
R
P
EMOTE
HONE
, or, for IP phones, the
Number
6-13
Advertisement
Table of Contents
