Ov6. Data Retrieval Options; Telecommunications Telecommunications Commands - Campbell CR510 Operator's Manual

CR510 OVERVIEW

OV6. DATA RETRIEVAL OPTIONS

There are several options for data storage and
retrieval. These options are covered in detail in
Sections 2, 4, and 5. Figure OV6.1-1
summarizes the various possible methods.
Regardless of the method used, there are three
general approaches to retrieving data from a
datalogger.
1) On-line output of Final Storage data to a
peripheral storage device. On a regular
schedule, that storage device is either
"milked" of its data or is brought back to the
office/lab where the data is transferred to
the computer. In the latter case, a "fresh"
storage device is usually left in the field
when the full one is taken so that data
collection can continue uninterrupted.
2) Bring a storage device to the datalogger
and milk all the data that has accumulated
in Final Storage since the last visit.
TABLE OV6.1-1. Data Retrieval Methods and Related Instructions
Method
Storage Module
Telecommunications
Printer or other
Serial device
OV-16
3) Retrieve the data over some form of
telecommunications link, whether it be RF,
telephone, short haul modem, or satellite.
This can be performed under program
control or by regularly scheduled polling of
the dataloggers. Campbell Scientific's
Datalogger Support Software automates
this process.
Regardless of which method is used, the
retrieval of data from the datalogger does NOT
erase those data from Final Storage. The data
remain in the ring memory until:
They are written over by new data (Section 2.1)
Memory is reallocated or the CR510 is reset
(Section 1.5)
Table OV6.1-1 lists the instructions used with
the various methods of data retrieval.
Instruction/Mode
Instruction 96
8
9
Telecommunications
Commands
Instruction 97
Instruction 96
8
Section in Manual
4.1, 12
4.2
4.5
5
12
4.1, 12
4.2