The Rear Ports - Billion BiPAC 7402(G)X(L) Series User Manual

The Rear Ports

The Ethernet Port # 4 can be used as a console port. You need a special
console tool which already includes in the package to connect with LAN
port 4 and PC's RS-232 port (9-pin serial port).
Port
Antenna
1
(Wireless Router only)
DSL
2
USB
3
LAN
4 1X - 4X
(RJ-45 connector)
5 WPS (Wireless Router only)
6 RESET
Power
7
Power Switch
8
Chapter 2: Installing the router
Meaning
Connect the detachable antenna to this port.
Connect the supplied RJ-11 ("telephone") cable on this port
when connecting to the ADSL/telephone network.
Connect the USB cable on this port.
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
LAN ports when connecting to a PC or an office/home network
of 10Mbps or 100Mbps.
Caution: Port 4 can be either a LAN or Console port at a time
but not both.
Push WPS button for less than 5 sec to trigger Wi-Fi Protected
Setup function; push WPS button for more than 5 sec to
enable/disable WLAN Service.
To be sure the device is being turned on. Press RESET button
for:
1-3 seconds: quick reset the device.
6 seconds above, and power off, power on the device:
restore to factory default settings. (Cannot login to the router or
forgot your Username/Password. Press the button for more
than 6 seconds).
Caution: After pressing the RESET button for more than 6
seconds, to be sure you power cycle the device again.
Connect the supplied power adapter to this jack.
Power ON/OFF switch
6