The Front Leds; The Rear Ports - Billion BiPAC 7800VDPX Quick Start Manual

Quick Start Guide
H a r d w a r e O v
H a r d w a r e O v

The Front LEDs

When the system is ready,
the LED will be lit green; lit
red when the device fails to
boot or in emergency mode.
Lit when successfully connected
to an Ethernet device, lit green for
1000Mbps, Orange for 100Mbps,
and blinking when data is being
transmitted/ received.

The Rear Ports

Connect to an
analog phone
Dual band
set with RJ-11
antennas
cable.
Connect to the ADSL
/ telephone network
with RJ-11 cable
(telephone).
*Note: For WPS configuration, please refer to the WPS section of User Manual.
e r v i e w
e r v i e w
Lit green when wireless
is enabled; unlit when
wireless is disabled.
Flash green when
WPS configuration
is in progress; unlit
when WPS fails.
Connect your computer to a LAN port
with the Ethernet cable included.
E W A N : I t o f f e
E W A N : I t o f f e
for connecting to Cable Modem, VDSL,
fibre modem or PON optic lines with
RJ-45 cable.
Connect to the
telephone jack on
the wall with RJ-11
cable.
Lit green when
the phone is
off-hook.
Lit when successfully
connected to PSTN.
r s p o r t # 4 a s a W A N p o r
r s p o r t # 4 a s a W A N p o r
Push WPS button
Connect the USB
to trigger Wi-Fi
cable on this port.
Protected Setup
function.
2-
-
Lit red when WAN port fails to
get IP address; lit green when
WAN port gets IP address
successfully. Unlit when the
device is in bridge mode or
WAN connection is absent.
Flash green when the device is
establishing the active DSL link
; lit green when successfully
connected to an ADSL DSLAM,
("line sync"). Unlit when the DSL
link has not been established
Press the "Reset"
button for 5 seconds
and above to restore
t
t
the factory default
settings.
Connect the
supplied power
adapter to this
jack.
*
Power
ON/OFF
switch