Factory Default Settings - Billion BiPAC 7402(G)X(L) Series User Manual

Factory Default Settings

Before configuring your router, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you power
cycle the device again.
Attention
Attention
Device LAN IP settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs
Chapter 3: Basic Installation
192.168.1.254
255.255.255.0
Enabled
100 IP addresses
192.168.1.100 through 192.168.1.199
(802.11g) ADSL2+ (VPN) Firewall Router
WAN Port
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP.
continuing from
18