The Rear Ports - Billion MWEB W40 Quick Start Manual

The Rear Ports

The Ethernet Port # 4 can be used as a console port. You need the special
console adapter, included in this package, to connect the LAN cable of Port 4
when connecting to a PC's RS-232 port (9-pin serial port). Note that the console
port is for emergency use only, and should not be used by default.
Port
Power Switch
1
Power
2
3 RESET
WPS
4
LAN (YELLOW)
5
1 — 4
(RJ-45 connector)
DSL (RED)
6
Antenna
7
MW/W40 V4.0A-090115
Power ON/OFF switch
Connect the supplied power adapter to this jack.
After the device is powered on, press it to reset the device or
restore to factory default settings.
1-3 seconds: reset the device
6 – 8 seconds: restore to factory default settings (this is useful
when you have forgotten the router's administrative password).
Note: If the reset button is pressed for more than 10 seconds
the device will need to be power cycled before normal
operation can be resumed.
Push WPS button to trigger Wi-Fi Protected Setup function.
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
LAN ports when connecting to a PC or an office/home network
of 10Mbps, 100Mbps.
Connect the red RJ-11 cable to this port when connecting to
the phone-line jack on the wall via the red "DSL" port on the
splitter.
Connect the detachable antenna to this port.
MWEB ADSL Wi-Fi Router
Meaning
Page 5