Switching Off; Using The Rcu - Barco FLM R22+ User Manual

Switching to Standby. When the projector is running and you want to go to standby, press the standby key
for 2 seconds. Do not press any longer on the standby key otherwise the projector will restart.
All custom settings are written to the internal backup device. A message 'Save data ...' indicates this process.
Never switch off the projector while this message is displayed.
When pressing for at least 5 seconds on the Freeze button, the projector goes to standby without the risk of
restart..
6.3.4

Switching off

How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector with the power switch.
C
AUTION
6.4

Using the RCU

Pointing to the reflective screen
1. Point the front of the RCU to the reflective screen surface.
Screen (B)
Image 6-4
IR control via the reflective screen
A Remote control
B Screen
C Front IR-sensor
Hardwired Remote Input
1. Plug one end of the remote cable in the connector on the bottom of the RCU.
R59770179 FLM R22+ 15/03/2010
:
Never switch off the projector while the message 'Save data ... ' is displayed !
IR Sensor (C)
6. Getting started
Remote Control (A)
47