Troubleshooting; Error Codes - Barco FLM R22+ User Manual

21. TROUBLESHOOTING

21.1 Error codes

Overview
When the error code is preceded by a '-' sign, then the error means a real error for the projector.
When the error code is preceded by a '+' sign, then the error code means a warning. The projector does not fail yet, but take care
for the warning and try to resolve the problem. A warning state can turn into an error state.
Not all error codes can have two states. When the state is available, it is indicated by a Yes in the overview table. When the state
is not available, it is indicated by a No.
Error Description
code
1000 Wrong lamp
parameters
↓
1017
1499
1498
1699 Formatter busy
1698 Formatter
address
1697 Formatter init
failed
1696 Formatter ctrl
init failed
1695 Red form. start
failed
1694 Green form.
start failed
1693
Blue form. start
failed
1692 Form.
PWRGood
2000 No lps detected
2001 Mains voltage
too low
2002 Lamp start
failed
2003 Main voltage
too high
2004 Lamp goes out
2005 Lamp stop
failed
2201 PFC start failed
2501 PFC start failed
2801 PFC start failed
2202 LPS start failed
2502 LPS start failed
R59770179 FLM R22+ 15/03/2010
Error Warning Caused by
-
Yes Wrong lamp/ no communication
with lamp
-
Yes no communication with formatter
ctrl
-
Yes
no communication with formatter
ctrl
-
Yes no communication with red
formatter
-
Yes no communication with green
formatter
-
Yes no communication with blue
formatter
-
Yes formatter 'Power Good' signal not
OK
-
Yes no communication with lamp power
supply
-
Yes mains voltage too low
-
Yes Hot restrike
Lamp with many strikes
maximum run time exceeded
Lamp or LPS or SPG failed
-
Yes mains voltage too high
-
Yes
-
Yes
-
Yes LPS (address 0x20)
-
Yes LPS (address 0x22)
-
Yes LPS (address 0x28)
-
Yes LPS (address 0x20)
-
Yes LPS (address 0x22)
21. Troubleshooting
Action
Check lamp type
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Let cool down the lamp for at least
5 minutes. Retry a few times.
Replace the lamp with a new one
Replace LPS or SPG or cabling.
Call qualified service engineer
Call qualified service engineer
Replace LPS
Replace LPS
Replace LPS
Replace LPS
Replace LPS
213