Operating The Projector; Switching On - Barco FLM R22+ User Manual

Ind. Key name
14
PHASE
15 FREEZE
16 TEXT
17 ENTER
18 Cursor keys
19 EXIT
20 WINDOW
21 PIP
22 RC Operating indication
Table 6-1
6.3

Operating the projector

Overview
•

Switching on

• Errors, warnings and messages during start up
• Switching to standby
• Switching off
6.3.1 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
Image 6-2
Switching on
- When '0' is visible, the projector is switched off.
- When '1' is visible, the projector is switched on.
The projector starts up in standby. The menus are accessible via the local LCD panel.
To display an image, the standby key must be pressed once.
R59770179 FLM R22+ 15/03/2010
Description
Used to remove the horizontal instability of the image (usually for RGB source). It adjusts
the phase of the pixel sampling clock relative to the incoming signal.
To freeze the actual projected image. Freeze sign is displayed in the upper left corner (a
short press on the key).
When pressing for 5 sec, the projector goes into stand-by. The lamp cooling fans remain
active for about 5 minutes. The speed of the other fans is reduced.
Toggle key to activate or deactivate on screen text boxes while adjusting a setting.
When adjusting one of the image controls, e.g.during a meeting, the normally displayed
bar scale can be deactivated by pressing 'TEXT' key first. To re-display the bar scale
on the screen, press 'TEXT' key again. When TEXT is 'off', no adjustment menu's
will be displayed on the screen when entering the adjustment mode. All menus and
adjustments remain active on the local LCD panel.
Key to confirm an adjustment or selection in the adjustment mode.
To make menu selections when in the adjustment mode
Key to go one menu stage higher than the actual position when in the adjustment mode.
Selection of the active window, also in PIP mode.
Direct access key for picture in picture selection.
Lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
6. Getting started
45