Restore Factory Defaults - Barco FLM R22+ User Manual

14. Service menu
The internal service pattern window opens.
4. Use the ▲ or ▼ key to select the desired patterns and press ENTER.
When a pattern is selected, press ENTER to toggle to other patterns of the selected type. Press EXIT to return to the internal
service pattern menu.
Image 14-40

14.6 Restore factory defaults

What can be done?
All settings of the projector will be set to the original factory settings with the exception of :
• IP address
• Serial settings
• DMX settings
• Electronic convergence
For these settings the choice exists to exclude them in the reset operation. .
With this operation, all user settings with the exception of the above mentioned are erased.
How to make an exception
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Service and press ENTER.
The service window opens.
3. Use the ▲ or ▼ key to select Restore factory defaults and press ENTER.
The factory defaults confirmation window opens.
4. Use the ▲ or ▼ key to select the setting to exclude and press ENTER to toggle between [No] and [Yes].
Repeat this step if necessary for the other settings.
Image 14-43
174
Image 14-41
Image 14-44
Image 14-42
Image 14-45
R59770179 FLM R22+ 15/03/2010