Getting Information - Barco Coronis 5MP Installation & User Manual

Operation
3. Turn the wheel to select the desired menu item.
4. Perform the settings as described below.
The Settings menu contains the following items:
DPMS
Power LED
User Controls

Getting information

The Information menu allows you to get information about the
display and the connected signals.
78
Click the control wheel to switch
on/off the automatic power saving
system (DPMS)
Click to switch the power LED on/
off. Note: The LED's orange DPMS
state is not influenced by this set-
ting. So, when the display goes into
power-saving mode, the LED will
turn orange, even if it was switched
off by this setting.
Click to disable the control wheel
functions so that the on-screen dis-
play cannot be used after quitting
the OSD menus.
To enable the control wheel func-
tions again:
a) Do not use the wheel for at least
3 seconds
b) Turn the control wheel 1 click
clockwise
c) Click the control wheel 2 times
d) Turn the control wheel 1 click
counterclockwise
e) Select the Settings menu and
switch Local controls on again.
Actions b, c, d have to be performed
in a sequence that takes no longer
than 3 seconds.