Barco Coronis 5MP Installation & User Manual page 100

Setting the resolution of your C
display connected to your BarcoMed controller. Both displays of a
display controller cannot be enabled at the same time unless
their display properties match. If necessary detach the second
display of the BarcoMed display controller you are working with
by right clicking on the rectangle that represents it, deselect
Attached and click the Apply button.
Since Windows will not let you detach the primary display
Note:
connected to a particular controller, you may need to temporarily
make another display the primary display
4. For the display which is still attached click Click on the
Advanced Button.
5. Select the Adapter tab and then click on the List All Modes
button. Select the resolution and refresh rate that your
Coronis 5MP display supports from the dialog box and click
OK.
In the Adapter box, the Adapter string shows if this display
Note:
is the First View or the Second View attached to the display
controller. Please make a note of this, so that you can arrange the
displays in the correct order later if necessary.
6. Click OK on the bottom of the Adapter Control Panel. If the
"OK" button on the bottom of the Adapter Control Panel is
not visible, press the TAB key once and then press
CTRL+Enter to select OK.
7. Click OK in the "Windows will now apply your new desktop
settings" dialog box. Your Coronis 5MP display should now
synchronize and display the Windows desktop.
8. Click Yes when asked, "Your desktop has been reconfigured.
Do you want to keep these settings?"
To set the resolution of the second display attached to the
BarcoMed display controller you are working with, go back to
the "Settings" tab of the "Display Properties Control Panel".
If necessary attach the second display you detached in step 2
above, by right clicking on the rectangle that represents it
and selecting Attached.
100
5MP display
ORONIS